On a used Nissan Juke, the recall to clear first is the fuel pressure sensor problem: 12V-069 on 2011-2012 cars, 14V-683 on 2012-2014 cars, and 18V-156, which went back to 2011-2012 Jukes whose earlier fix may not have been tightened properly. A loose sensor can leak fuel, and NHTSA flags a fuel leak near an ignition source as a fire risk. The rest of the Juke list is short. NHTSA's API returned seven Juke campaigns for 2011 through 2017 when I pulled it on November 21, 2026, and the 2015-2017 cars have only one, a brake recall limited to the Nismo RS.
The fuel pressure sensor, three campaigns deep
This one is layered, and that's what trips buyers up. 12V-069 came first: Nissan said fuel pressure sensors on 2011-2012 Juke, Infiniti QX and Infiniti M vehicles may not have been tightened to spec at the factory, so heat and vibration could loosen them and let fuel leak. It listed 79,275 potential units, and dealers replaced the sensors as needed starting April 2, 2012. Then 14V-683 expanded the problem to 2012-2014 Jukes plus some V8 Infiniti models, 133,592 potential units, with dealers re-torquing the sensors starting January 25, 2015.
The third piece is the annoying one. 18V-156 covers 2011-2012 Jukes that were already fixed under 12V-069. During that earlier remedy, the sensor may not have been tightened properly, so it could still loosen and leak. That's 49,385 potential units, and the fix is another trip to the dealer to torque the sensor, starting April 24, 2018. So a 2011 or 2012 Juke with one recall receipt from 2012 is not finished. You want the 2018 visit on record too, or a dealer printout showing nothing open. If you smell raw fuel around the engine bay after a drive, walk away until a dealer has looked at it.
Why does the sequence matter so much? Because a VIN lookup shows each campaign separately, and a seller who honestly believes the car is "done" may only know about the 2012 visit. Nissan's recall notices list customer service at 1-800-647-7261, and a Nissan dealer can print the open and completed campaigns for the VIN. Ask for that printout, and check that 18V-156 shows as completed on a 2011 or 2012 car, in addition to 12V-069. A printout that lists only the first campaign leaves the question open. On a 2013 or 2014, 14V-683 is the one to match.
2011: the turbo boost sensor bracket
11V-583 applies to 2011 Jukes built April 9, 2010 through May 12, 2011, 28,294 potential units. A defective weld can let the turbocharger boost sensor bracket separate from the air inlet tube, and NHTSA says the car could then stall at idle without warning. Dealers check the lot number on the air inlet tube and replace it if needed; the campaign was expected to begin around January 9, 2012. A first-year Juke can have this and the fuel sensor campaigns open at the same time, which is why I'd run the VIN before even scheduling a test drive.
2012 rear seat strikers and the 2013-2014 start button
12V-328 covers 2012 Jukes built February 3 through May 26, 2012, 11,076 units. Incomplete weld penetration means the rear seat back striker may partly separate in a crash, so the seatback might not stay put. Dealers replace the strikers. Then 15V-418 covers 2013-2014 Jukes built July 3 to October 22, 2013, along with some Versa sedans and Cubes, 14,595 units in total. In hot weather the push-button start can stick inside its housing, and road vibration may then shut the engine off while you're driving. Dealers modify the switch housing, and that campaign began August 4, 2015. On a test drive in summer, press the button a few times with the engine off and see whether it springs back cleanly.
2015-2017: just the Nismo RS brake fix
The later Jukes are clean by comparison. The only campaign the API returned for 2015, 2016 and 2017 is 18V-086, which covers 415 Juke Nismo RS cars. Brake fluid can leak from inside the master cylinder into the brake booster, which lengthens stopping distances; dealers replace the master cylinder, a campaign that started March 19, 2018. If the car is a regular S, SV or SL, that one won't apply. Car and Driver describes the later Juke with a 188-hp 1.6-liter turbo four, front-wheel drive with optional all-wheel drive, and a CVT as the only transmission, which matters more for your maintenance budget than the recall list does.
By year, and what to do next
By model year the API counts were three for 2011, four for 2012, two each for 2013 and 2014, and one each for 2015, 2016 and 2017. A model-year list is a starting point only; inclusion is decided by VIN and build date. Plug the VIN into NHTSA's lookup or see our Nissan recall check by VIN guide, then read the used Nissan Juke buying guide for the CVT and turbo questions. Our Nissan VIN decoder helps confirm you're looking at the trim the ad claims, which matters for that Nismo RS brake campaign.
Look, a Juke is now an old, cheap, quirky car, and the people selling them aren't always careful. A recall lookup won't show you a salvage brand, a flood history or a mileage rollback. Run a history report on this exact VIN and skip any report the seller emails you, since a forwarded report can belong to a different car entirely. For the record, we resell CARFAX and AutoCheck under license and have no tie to CARFAX, AutoCheck or Experian themselves; nobody gives the full official report away. The retail price elsewhere tends to sit between $39.99 and $44.99. Ours has been about $5.50 as a guest, $4.50 for members and $6.75 for a bundle, but confirm at checkout because pricing changes.

Comments (0)
No comments yet. Be the first to share your thoughts!
Log in to leave a comment.